Recent content by TheChick3n

In response to Americanaudiophile: the mixer has a headphone jack output also, and when I use me headphones, the audio sounds clean, and there are no clip LEDs Turing on at all. the EQ and crossover both have clip LEDs which are not turn in on either at the time when the amp clips. the gain on...

The amp only does this with audio playing. If there are no inputs with gain set at its highest lever, all you'd hear is a soft hissing sound. Switching the channels and inputs did the same thing. I have an active crossover in stereo mode, but I'm only using the left output of the X-Over Also...

I have a QSC RMX 850 (not the 850a) and I have it set to stereo mode with channel 1 for the mids and highs and channel 2 for a subwoofer. I do have a crossover setup correctly So the problem occurs when there is a lot of bass playing and I try to turn it up. The signal LED is barely lighting up...

I have a QSC RMX850 watt amp. I want to connect my laptop to the amp through a 1/4 inch cable using a 3.5mm (The headphone jack size, Please correct me on that one if it was wrong.) adapter. I also have a mixer and when I turn on the amp, the mixer shows some output signal. I don't know if...

Actually, I'll upload pictures. http://prntscr.com/3iy5lg - That's what I normally had it. But for somereason, I have to lower them to.. http://prntscr.com/3iy63e I have to lower them because it's something about the sound that changes.. Softens. I use earbuds and sometimes iEdge headphoes...

I have a C-Media PCI audio card. The software comes with an equalizer. Lately, I have had to lower the levels for frequency 30-120 down more than I normally would have. It used to be fine, Normally, I have them set to 30, 18DB; 60, 16DB; 120, 15DB; 250, 6D; 500, 0; 1K, 1DB; 2K, 3DB; 4K, 10DB...