how to wire 2 kickers cvr 12'' to 5 channel amp mb quart 1100.5

The instructions for that amp don't make any sense do they?
The safe way to hook them up is to connect both voice coils of each woofer to a single channel of the amp in parallel so they present a 2 ohm load to each channel. That is safe for the amp and will provide 300 watts for each woofer. DON'T bridge the amps. It's not clear what load it can handle bridged. You can set the mode switch to mono if you don't want left and right woofers.
If you are using the internal crossover in the amp set the Xover switches for all four channels to LPF.
 
The instructions for that amp don't make any sense do they?
The safe way to hook them up is to connect both voice coils of each woofer to a single channel of the amp in parallel so they present a 2 ohm load to each channel. That is safe for the amp and will provide 300 watts for each woofer. DON'T bridge the amps. It's not clear what load it can handle bridged. You can set the mode switch to mono if you don't want left and right woofers.
If you are using the internal crossover in the amp set the Xover switches for all four channels to LPF.
 
Thread starter Similar threads Forum Replies Date
J Audio 0
H Audio 0
NaveenAnand Audio 1
A Audio 0
D Audio 0
Kevcam111 Audio 1
I Audio 3
Lbray6133 Audio 1
Adam552 Audio 0
Jimmiew0612 Audio 0
H Audio 2
kary_R Audio 1
M Audio 1
T Audio 3
J Audio 3
K Audio 2
K Audio 1
T Audio 2
E Audio 4
wolf201 Audio 8

ASK THE COMMUNITY