M50x bad soldering, will it last?

[Guest]

Gently opened right earcup; found this.
https/drive.google.com/open?id=0BzfcycWSiacLQmdfdkxxZktPN3c
https/drive.google.com/open?id=0BzfcycWSiacLbl9keGFkZzJ5a1k
https/drive.google.com/open?id=0BzfcycWSiacLMnpVRlRrb3lTUzg

Will it last?

 

[Eximo]

Not the worst soldering job ever. You can always reflow it if you are concerned.

 

[Guest]

I don't really have any soldering equipment...

 

[boosted1g]

As long as the cable (at the point where it goes into the headset) does not get pulled on a lot then it should be fine.

 

[Eximo]

Cheap soldering irons can be found for around $15. Might be able to get it done cheap or free at an audio store that offers repair if you ask nicely.

I am a little surprised the only thing keeping the wires from shorting together is that they used magnet wire for one of them. I suspect that will have a breakage before the cold soldering joint causes a problem.

 

[Guest]

You think I could get that done in NYC? I currently live in Qatar (limited tech stores and services), and I am going to visit manhantan soon.

 

[Eximo]

Not from the area, but I imagine there are many audio repair shops around NYC.

 

[ccampy]

That is quite bad it almost looks like a bad repair with a cheep iron that dosnt heat up to temperature correctly

It shouldn't break as long as it doesn't get too much stress