Solved! My son's Lenovo tab tb-x304L, the display goes off and comes back

Aug 28, 2019
1
0
10
My son's Lenovo tab tb-x304L, the display suddenly started giving problem, it goes off for few seconds and comes back and sometimes don't come back, sometime show display with broken and fluctuating display.
Please advise
 
Solution
Try starting up the tablet in "Safe Mode" and see if it acts the same in there. If it does, then you need to either have the tablet looked at and possibly repaired, or get a new tablet. However, if the problem does not happen in "Safe Mode" then there is likely something on the table that is the problem. Bad app, virus, malware, etc. To resolve it you would then have to remove the problem either by searching the device with software for viruses and malware or do a full "Hard Reset" of the tablet which would wipe everything on it and take it back to its original state prior to any use.

To get into "Safe Mode" please do the following.

1. First turn off the tablet.

2. Next press and hold "Power" until you see the manufacturers logo on...
Try starting up the tablet in "Safe Mode" and see if it acts the same in there. If it does, then you need to either have the tablet looked at and possibly repaired, or get a new tablet. However, if the problem does not happen in "Safe Mode" then there is likely something on the table that is the problem. Bad app, virus, malware, etc. To resolve it you would then have to remove the problem either by searching the device with software for viruses and malware or do a full "Hard Reset" of the tablet which would wipe everything on it and take it back to its original state prior to any use.

To get into "Safe Mode" please do the following.

1. First turn off the tablet.

2. Next press and hold "Power" until you see the manufacturers logo on the screen, then release the power button.

3. "Quickly" press "Volume Down" and hold it for few seconds until you see the message "Safe mode: ON" or something similar.

4. If you wanted disable it, simply repeat the steps above, and you should see "Safe Mode: OFF" rather than on.
 
Solution