Power Jack replacement

[amac2000]

I have just replaced the power Jack does anyone know how to test connections prior to re-installing motherboard into laptop.

I want to check that I have soldered properly and connections are good.

Thanks
Andy

 

[vrumor]

If youve soldered that into place, youve probably passed the technical knowledge of most people on these forums.

 

[mcnumpty23]

you should be able to bench test it by plugging in the charger and pushing the little button that would be below

the on -off switch

dont do this if you removed the cpu heatsink

if the cpu fan spins then powers going through the power jack and you can re-assemble it

 

[amac2000]

Thanks for the replies but it is my 1st attempt at soldering and I want to make sure that the soldered connections are okay prior to powering upas dont want to short out m/board.

I have removed heatsink and processor.

thanks Andy

 

[ram1009]

You risk damaging something if you apply power. You need an ohmeter to check continuity between the contacts on the jack and the solder pads on the MB.

 

[mcnumpty23]

well if you have a multimeter and know how to use it then test it with it

but unless you have went badly wrong you should be able to see the points you soldered and see that you

havent joined any off them together--like here

http/www.youtube.com/watch?v=Im_n9K-14_I