Speaker and amplifier connection!

Sep 19, 2018
1
0
10
0
Hi,

I recently found a Sonken SA 700 RS amplifier lying a few streets down mine, it seemed pretty fine so I thought I should take it home as it may be of some use to me. Later in the week, I found a pair of speakers around the same area. The speakers seemed like one of those speakers with inbuilt amps and with all input features(line in, USB etc). I thought to myself and started experimenting with the equipment that I found. I connected the speakers to the amplifier and gave it an input as well. The music played through the speakers, but the only problem was that the sound was very faint. I tried increasing the volume of the amp itself and the input source but there was no effect.
The speakers have two 25W speakers each of 8ohm impedance each and the amplifier has an output power of 350W + 350W. I am not very well known to the technicalities of the equipment, but would very much like them to work.
I would really appreciate any help.
Thank you.
 
On the back of the mixer-amp there should be preamp output - amp input stereo RCA jacks. There may be 2 jumpers to connect them.
If they are not there then there is no connection from the preamp to the amp inside the Sonken so no sound from the speaker terminals. If you had passive speakers you would use a set of stereo RCA audio cables to replace the missing jumpers.
If they are there then turn the amp off and remove the jumpers.
In either case you can connect the powered speakers to the L/R RCA preamp outputs.
 
Thread starter Similar threads Forum Replies Date
D Audio 3
G Audio 2
V Audio 7
V Audio 7
M Audio 1
T Audio 7
T Audio 1
S Audio 5
V Audio 13
W Audio 2
S Audio 1
G Audio 7
R Audio 1
M Audio 2
R Audio 4
R Audio 1
J Audio 8
3Bass Audio 1
A Audio 4
A Audio 7
Similar threads
Question connecting my old sony speakers with an amplifier
Need help connecting 5 speakers in parallel to an amplifier.
How to connect 6 speakers into 2 channel amplifier? What happens to the watt requirement?
How to Connecting 5.1 speakers to lepy 2 channel audio amplifier?
I have yamaha ns100x 6 ohms speakers and connected it to my konzert KA-711+ 8 ohms amplifier. Is it ok? Do they compatible?
problem connecting samsung smart tv with 5.1 active speakers using 5.1CH HDMI Audio Extractor Decode AC3/DST to 5.1 Amplifier
How to connect bose speakers to 100 volt line from the amplifier
Connecting a centre speaker to a stereo amplifier
I bought Pioneer Vsx 330K amplifier but my subwoofer is passive can I connect the wires to front speaker
Can i connect 1200watt subwoofer and speaker to my pc without amplifier?
My bro mistakenly connected two 100 watts beta4 speakers to 800 watts crown amplifier for a few seconds to check whether speak
Two sets of wires out of AIWA speakers to connect to AKAI AM-2200 amplifier
Can i connect 8ohm speakers directly to a preamplifier without using a power amplifier?
Can i connect 1 pair of 1000watt speaker to 1800watt (amps) amplifiers
how to connect pioneer stereo amplifier A-X530 to isis is42913led3d tv
Wire confusion - connecting Passive Klipsch R-14 Speakers to Harmon Kardon 3490 Receiver
Is it possible to connect two passive speakers to only one amplifier output?
how can i connect a pa amplifier with two passive speakers and an active sub woofer to my behringer xenyx 1204usb?
I have two speakers each of 50W which is connected to a 250W Amplifier. Do this connection makes any damage to my speakers?
how to connect my speakers to this special type amplifier

ASK THE COMMUNITY

TRENDING THREADS