Vintage 4-pin microphone female to 1/4 mono

meredithfuzia

Prominent
Aug 17, 2017
6
0
510
How to configure
a vintage 4-pin
wiring schematic to
1/4 mono
With a replacement microphone cord
Am radio - workman MIL 10
Has 5 tiny wires plus ground/shield
Red, Black, White, Blue, White
Need help. Thank you.
I've been watching YouTube videos to try and figure it out myself.
Thanks.
 

meredithfuzia

Prominent
Aug 17, 2017
6
0
510


 

meredithfuzia

Prominent
Aug 17, 2017
6
0
510


 

meredithfuzia

Prominent
Aug 17, 2017
6
0
510
MERGED QUESTION
Question from meredithfuzia : "Vintage 4-pin wiring schematic to 1/4 mono: Help Needed"

Need Advice on how to:
Vintage 4-pin wiring schematic to
1/4 mono
That's what Radio Shack employee told me I needed to do.
I have a Fen-tone Dynamic Microphone Stock # F86/1861 that did not come with a cable wire to connect to a speaker. It has a 4-pin male. Have been watching YouTube and researching on internet to try to figure out how to diy microphone cord.
Have all the parts: Ham/CB/audio 4-pin female mic connector. Replacement MIC Cord...am Radio - Workman MIL 10. It came with Neutrik 1/4 mono connector.
I put picks on Imgur.com under the same title as above.
Here's what I've done:
Cable has 5 small wires and ground inside. Red, Black, White, Blue, Yellow, and shield/ground. I clipped the yellow off. Twisted the blue and ground together. For the back side PIN numbers I soldered Red to 1. White to 4. 2 to Blue/Ground. 3 to Black. Got that all put back together. How should I wire the other side to the Mono 1/4 Neutrik plug?
Please advise! Any help is greatly appreciated! Thank you.
Pictures of wires, etc. on Imgur.com
Under title:
Vintage 4-pin wiring schematic to
1/4 Mono.