Recent content by DaleMe

Out of the box the unit is set to EDID=AUTO and the two DIP switches are OFF. I have run tests in all possible combinations of the EDID setting and the two DIP switches with the same outcome: When the TV on the 50 foot HDMI cable is turned on the audio on the TV connected to the 3 foot cable...

Thank you for your suggestions. I have swapped out cables and always get the same results. The only test I have done with positive results has been when I use my laptop as the HDMI source. Then I get audio and video on both TVs. The service provider says they do not have technology in place...

I recently switched from a DirecTV STB to a fiber provider supplying TV service with an Arris VIP5662W IP receiver. With the DirecTV setup I used an HDMI splitter to send the signal to two TV sets, one near the receiver and another in the basement. This setup worked for two years flawlessly...