jdenova007 :
right. it's called an I/O board, and usually it is a separate piece of hardware from the mobo, but it does send a signal through the motherboard(it has to to interact with all the other components).
what's weird is it actually turns the laptop on... it is a touch-sensitive interface right? it isn't like your physically pushing a button, it just "senses" your touch... which would NOT work if the laptop is actually powered off..(i dont think)
it sounds like when you push power... the pc sends a voltage "loop" through the system to verify all components are getting signal, then it will boot... but your "loop" isn't getting the response it requires, so it turns on then turns off. this can be caused by many things, mainly hardware. i.e. processor, motherboard, RAM, wireless card... i have seen all of these components cause this issue.
what's weird is it actually turns the laptop on... it is a touch-sensitive interface right? it isn't like your physically pushing a button, it just "senses" your touch... which would NOT work if the laptop is actually powered off..(i dont think)
it sounds like when you push power... the pc sends a voltage "loop" through the system to verify all components are getting signal, then it will boot... but your "loop" isn't getting the response it requires, so it turns on then turns off. this can be caused by many things, mainly hardware. i.e. processor, motherboard, RAM, wireless card... i have seen all of these components cause this issue.
Is the possible hardware fault likely to be related to the known HP wireless failure on my HP Pavilion DV9000 and if so could there be some way of resurrecting the wireless adapter by manipulating the "quick play" setup?