Hey,I need a new fuse for my speaker because it blew and no stores stock it. Its a T2AH 250V 2A Slow blow fuse. Its ceramic so

[Jacob Smith]

Hey,I need a new fuse for my speaker because it blew and no stores stock it. Its a T2AH 250V 2A Slow blow fuse. Its ceramic so I was wondering if this glass fuse from here would fit the bill?
Im in AUS and other T2AH fuses are from china and US and much more costly. Like 1 dollar for the fuse and 20 for shipping so.

http/www.ebay.com.au/itm/1-x-Glass-Fuse-Fast-or-Slow-Blow-Size-5-x-20-mm-or-6-x-30-mm-AU-local-fast-ship-/141676818980?pt=LH_DefaultDomain_15&var=&hash=item20fc98b224

Also can I be advised on the correct size for the fuse? Not too sure if 5x20 or 6x30.

I have a logitech z680.

 

[Jacob Smith]

'Slow' blow means it is somewhat resistant to inrush currents that cause nuisance tripping.
Its an inductive load,coils etc and the start up current can be a lot higher than running current.
If it has been in use for years and blown, just get a few ordinary 20 mm 2 amp fuses (not quick blow or anti surge) and be prepared to change them a bit more often.They usually come in a pack of ten for about a £1.
Glass surround is fine, ceramic is for 'elf n safety' reasons.If 2 amp fuses go often, move up to 2.5.
Its unlikely the problem is anything but the fuse size if the equipment has been in service reliably for a long time.

So that would be the 5x20 size right? Thanks a lot for the answer, really clarified my confusions/

Thanks c: