Recent content by BmoneyGames

Hello! I have a pair of Vmoda LP headphones and I want to wire them to my computer, but the cable is a combo cable (mic and audio in one cable) And my desktop has 2 ports in front ( mic and audio) is there any way I could wire one of those ports to both support audio and mic? Maybe in the BIOS...

Hello! I have a pair of vmoda lp's and after about 20 mins of use my ears start to feel soar cause they are touching the speaker in the headphones is there a way i can fix that so that my ears arent touching the speaker

And have you tried plugging in another set of headphones just to make sure your earbuds are not defected?

On the front of your computer do you have 2 jacks? once for mic and one for audio? or is a single jack with both audio and mic? cause if you have 2 ports, your answer lies in the playback/recording tab if you right click the audio icon on the lower right corner. make sure your apple earbuds are...

15 ohm isnt hard to power. But if you really wanted to take it up a notch, id have to reccomend: Fiio E6 AMP Its a cheap amp (Round 27$) but it will easily take your headphones above and beyond. But since its only 15 ohms i have do say to not get an amp at all.

Or if you want to mic on your headset you can get the G930 and buy the ModMic 4.0 and attach it to the g930. They have excellent quality and clarity.

Have you looked at the Logitech G930? They are a great headset spite the fact that they do have a buzzy-felling mic. Id say get this headset if you care more about the actual value of the headset over mic clarity. There are better mics on other headsets but you would have to stretch the budget a...

All i've heard about is how good these headphones are and i was thinking of getting a pair. So i did some reasearch and found of pair of the original m50's on craigslist for $75. And i found a pair of the m50x's on amazon for $140. Is the m50x's worth the extra 75 bucks or should i pick up the...

Im planning on getting the ath-m50x headphones and i wanted to know if i could tell how many ohms my card can output to determine if i need an amp.