ampex mm 1200 part needed

ANON

Distinguished
Feb 26, 2003
87
0
18,580
0
Archived from groups: rec.audio.pro (More info?)

hex nut/screw that holds the guide arm on right side of machine snapped in
two

need new hex nut

ideas?
 
G

Guest

Guest
Archived from groups: rec.audio.pro (More info?)

anon <anonymousm@nyc.rr.com> wrote:
>hex nut/screw that holds the guide arm on right side of machine snapped in
>two
>
>need new hex nut
>
>ideas?

Hardware store? Industrial fastener supply?

Check the tape tension too while you're at it, and the guide bearings.
--scott
--
"C'est un Nagra. C'est suisse, et tres, tres precis."
 
G

Guest

Guest
Archived from groups: rec.audio.pro (More info?)

In article <nhbbd.78307$Ot3.47513@twister.nyc.rr.com>,
anon <anonymousm@nyc.rr.com> wrote:
>
>doubt it would be at a hardware store
>
>it is a special hex nut attached to a threaded screw

What is special about it? I don't recall there being anything odd about it.

If you have the part number from the manual, George LaForgia has a garage
full of running spares for the master munchers.

Did you ask on the Ampex mailing list?
--scott
--
"C'est un Nagra. C'est suisse, et tres, tres precis."
 
Thread starter Similar threads Forum Replies Date
H Audio 0
D Audio 2
D Audio 0
L Audio 1
J Audio 0
J Audio 0
C Audio 3
G Audio 1
T Audio 1
Scarymovie Audio 0
C Audio 1
J Audio 4
kanyebread Audio 1
M Audio 1
D Audio 1
G Audio 1
G Audio 4
G Audio 1
G Audio 24
G Audio 1

ASK THE COMMUNITY