Need help connecting speakers

[tytyrox123]

On my receiver, the right channel plays beautiful sound out of the right speaker but the left channel does not play any sound

 

[alexoiu]

More details needed, regarding source (tv, pc...), cables used, ports, model of receiver and source.

 

[tytyrox123]

The model is a Kenwood VR-606 I connected to a center , left and right, and subwoofer speaker and when I press the test button they all work but when I hook up aux cables and play music sound only comes out the right speaker and the subwoofer , I have tried to factory reset nothing happens

 

[madmatt30]

Plainly the problem lies with the cables from your source to the receiver.

What are you running audio from , what cables are you using??

 

[tytyrox123]

I don't think it is the cables... I've tried the test mode and a little beep comes out of every speaker that is connected, but when I go to aux mode no music will play out of my center nor left speaker

 

[madmatt30]

What if you use the tuner ?? Are you getting sound from all speakers then ??

What do you actually have connected to the receiver with this issue & what cables exactly are connecting it??

 

[tytyrox123]

Ok so i tried connecting my aux cord with a side an aux and another side a red and whit e plug in, to the DVD mode on the receiver
, and now my left, right and subwoofer is working... so how do I get the center speaker to work... I'm using speaker cable to connect the speakers to the receivers

 

[americanaudiophile]

Follow the set up instructions in the manual
https/www.hifiengine.com/manual_library/kenwood/vr-606.shtml

 

[madmatt30]

If youre only connecting a stereo source or using a stereo cable then you're only going to get stereo sound.
Use the mode button on the Kenwood remote to change to Dolby prologic & you will get audio from every speaker connected.

Edit - its the listen mode key on the remote (2 buttons down from top right) that cycles between audio modes.