Question Replaced Dish with OTA

Jan 3, 2020
2
0
10
I pulled down my Dish Satellite and put up an OTA. I am pretty sure the direction is correct, but I am not seeing channels when I run a channel scan. I am using the same COAX that was already run so I presume its fine.

My question is out of the Dish Sat were two cables going into a box and two cables are going out to my TVs.

I only have one cable from the new OTA so I left it plugged in where it was in the splitter box and took out the other one. Then I attached to my OTA

The box has been painted so I cant tell if it was something special. I have tried both ports, without any luck. Any chance this is some special Sat only box? and I need to replace it with a simple splitter?
 
Last edited:
Jan 3, 2020
2
0
10
I was able to scrape the paint of the device and its a Solo Node 185834, so some quick searching seems to point to this being proprietary to Dish so maybe a splitter is in order