Stereo is fine but speaker not working

If you don't have a VOM you can connect a known working speaker to the same wires.
You can set a VOM to the lowest resistance range. If the meter shows an open circuit the voice coil is blown. The VOM would read slightly off the actual resistance rating of the speaker if it was OK.
 
If you don't have a VOM you can connect a known working speaker to the same wires.
You can set a VOM to the lowest resistance range. If the meter shows an open circuit the voice coil is blown. The VOM would read slightly off the actual resistance rating of the speaker if it was OK.
 
Thread starter Similar threads Forum Replies Date
C Audio 3
tomelks Audio 3
D Audio 2
E Audio 2
R Audio 1
C Audio 2
Clunker Audio 4
E Audio 1
L Audio 3
D Audio 15
J Audio 5
A Audio 2
A Audio 1
J Audio 3
J Audio 1
M Audio 2
J Audio 1
T Audio 1
M Audio 4
H Audio 2

ASK THE COMMUNITY