1 car amp, 2 svc subs that are different ohms

[Chris_338]

Car sub amp: 150rms×2@4ohms, 225rms×2@2ohms, 450rms×1@4 ohms (not 2 ohm stable bridged).

Car sub: svc 350rms 4ohm.
Home sub: svc 180rms 6ohm.

Home sub is box and speaker only (no amp)

Is there a way to wire these two subs to this amp in my car?

I believe bridged mode is out of the question since series wiring the two subs would bring them to 10ohms if I am correct, and parallel wiring would bring them down to 2.4 ohms.

Is it ok to run a 6ohm 180rms sub to one channel and a 4ohm 350rms sub to the other channel in two channel mode?

Help would greatly be appreciated as I already have the 4ohm 350rms car sub running bridged at 450rms from the amp at low gain level do to the amp being 100rms more than sub

 

[jsmithepa]

Run each sub on its own channel fine.