BSOD but cursor and keyboard don't work. Also, can't take battery off.

[Cande_]

Hello!
I have a Hewlett-Packard laptop with Windows 10. I was using it and I clicked the windows bar, but it lagged and then crashed. Afterwards, the screen was black but I could use the cursor (BSOD I think?) but then in my desperate attempts to get it functioning again, I pressed the Power button. And the cursor disappeared. So now I'm stuck with a completely black screen, while the computer is on (power button is lighted up). I've tried to press f8 but it doesn't work. I've also tried to open the Task Manager with the keyboard to no avail. Also, this model of the computer doesn't let me take off the battery. What can I do?
I appreciate your help

 

[webworkings]

Try this....

Make sure you wait until the computer would be fully loaded before trying this, and not try it right away like you would to say get into BIOS. This needs you to actually be where you would be when Windows Explorer loads.

1. Press "Shift" repeatedly until the "sticky keys" window show ups.

2. Now click the the link there that will lead to the "Ease of Access Center".

3. Next click "Cancel" on the the bottom right corner of the "Set Up Sticky Keys" window.

4. From here you want to click "Control Panel" on the upper left corner (it should be right beside the "Make Your Computer Easier to Use" title.

5. Locate the "Computer Settings" menu and then choose the "Recovery" icon (make sure that your view of this is by either large or small icons for easier access).

6. Now click and open "System Restore".

7. Here you want to click next on the bottom right corner (a few times) until the button "Finish" shows up and then click it. (Just follow everything prompt that the window says which will lead you to recovering your previous system, in a certain time.

8. The computer will now do the work it needs to and then reboot.


If that doesn't work, you can try the following...

You can also try doing the Ctrl+Alt+Delete and see if you can get "Task Manager" to show.


If the "Task Manager" windows shows, then choose "New Task" and then type in EXPLORER. If the desktop shows up then you need to go into "Start", "Programs", then "Accessories" and finally "Command Prompt". (Or you can do a search for CMD.)

Make sure you load the "Command Prompt" with Administrator access. Then when it loads type in....

SFC /SCANNOW

It will do a file check.

To learn more about "SFC" visit this link at Microsoft... https/support.microsoft.com/en-us/kb/929833