Dell Inspiron 14z won't boot up and gives 2 beeps.

[moar]

I have a dell inspiron 14z .The laptop's battery is dead and something wrong with the power of my laptop because when I shut it down the screen stays on but the HDD lights stop ,and this is how I normally shut it down , I just wait for the HDD lights to stop then remove the power cord.
Now I mentioned the above just to give an insight about the last thing that happened , last thing is that it was running then i shut it down with the same way i mentioned like I do normally . Next day I found the laptop not booting ,giving a black screen and just making 2 beeps. I searched for 2 beeps and it says it might be the RAM so I removed one ram of the two ,and switched places but nothing works.
Thanks in advance.

 

[webworkings]

See if this helps.

NOTE: Due to the fact that different manufacturers with this BIOS have different codes, the beep codes may vary.

Below are the AMI BIOS Beep codes that can occur.

1 short - DRAM refresh failure
2 short - Parity circuit failure
3 short - Base 64K RAM failure
4 short - System timer failure
5 short - Process failure
6 short - Keyboard controller Gate A20 error
7 short - Virtual mode exception error
8 short - Display memory Read/Write test failure
9 short - ROM BIOS checksum failure
10 short - CMOS shutdown Read/Write error
11 short - Cache Memory error
1 long, 3 short - Conventional/Extended memory failure
1 long, 8 short - Display/Retrace test failed
two-tone siren - Low CPU Fan speed, Voltage Level issue

Below are Award BIOS Beep codes that can occur.

1 long, 2 short - Indicates a video error has occurred and the BIOS cannot initialize the video screen to display any additional information.

1 long, 3 short - Video card not detected (reseat video card) or bad video card

Beeps repeating endlessly - RAM problem.

Repeated high frequency beeps while PC is running - Overheating processor (CPU).

Repeated beeps alternating high & low frequency - Issue with the processor (CPU), possibly damaged.

Dell beep codes

1 beep - BIOS ROM corruption or failure
2 beeps - Memory (RAM) not detected
3 beeps - Motherboard failure
4 beeps - Memory (RAM) failure
5 beeps - CMOS Battery failure
6 beeps - Video card failure
7 beeps - Bad processor (CPU)

Below are general IBM BIOS Beep codes that can occur. However, because of the wide variety of models shipping with this BIOS, the beep codes may vary.

No Beeps - No Power, Loose Card, or Short.
1 Short Beep - Normal POST, computer is ok.
2 Short Beep - POST error, review screen for error code.
Continuous Beep - No Power, Loose Card, or Short.
Repeating Short Beep - No Power, Loose Card, or Short.
1 Long and 1 Short Beep - Motherboard issue.
1 Long and 2 Short Beeps - Video (Mono/CGA Display Circuitry) issue.
1 Long and 3 Short Beeps. - Video (EGA) Display Circuitry.
3 Long Beeps - Keyboard or Keyboard card error.
1 Beep, Blank or Incorrect Display - Video Display Circuitry.