I have a popwind tablet that is doing the same thing

[john7974]

I can't disconnect my battery on my popwind table because the wires are soldered in place but might be long enough to cut and splice together so y'all think that would be ok to cut and splice back together or would it change the resistance or something

 

[webworkings]

Since you don't actually say what it is that is happening, there really is no way to answer the question. We would need a bit more details.

 

[john7974]

Sorry I been reading threads all day on it and I thought I was posting in that thread guess not......lol I have a popwind tablet that wont charge I got it to start charging for a half a second once I done took it apart and from what I read on the threads everyone has just had to disconnect there battery and put it back in after a couple minutes to reset mine is the same exact symptoms but my battery is sodered in it has 2 4 inch wires soldered into the circuit board and the battery no way to disconnect without cutting unless someone has a solution I don't know about

 

[webworkings]

Hmm That is quite odd. For it to be connected that way. I have yet to run into a tablet that was set up that way.


Anyone else have any suggestions?