Laser aspire won't load after Acer logo

Jan 20, 2018
4
0
510
I did factory reset on my ascer aspire and it won't load pass the Acer logo. I know lots of people had this problem but no solution work with me.
I try all the f8 f10..off-on my computer with no internet around for 4 times..etc.

Someone got a miracle solution for me ?
 
Try this...

1. Turn off the laptop.
2. Turn off your WiFi, or take the laptop to an area where there isn't any WiFi. (If connected via Ethernet, unplug it.)
3. Turn on the laptop.
4. Once it fully loads, then turn on your WiFi again.

It should work now. Sometimes (especially in 10) updates, including those that come after a reset, can get the computer stuck. It happens when an update fails, for whatever reason, and the device continually tries to get it to install over and over. Leaving you 'stuck'. Until you take away its ability to continue trying the update, hence the no WiFi, then it should load.
 
Jan 20, 2018
4
0
510


Thanks but still doesn't work. I can't reset it..I can't go pass the Acer logo even if it not plug on internet.
 
If the problem is a bad update or reinstall then a way around it is to start it up without a connection to the internet. This keeps it from trying to download whatever the issue was, again. Rather than getting stuck in a download, not install right loop. If that doesn't work, then it may be more than the software that is the problem.
 
Jan 20, 2018
4
0
510


Thanks but it did not work. Someone told me I can maybe put an older version of Windows on a drive and press F8 when the screen is black to upload it...but that did not work.
I'm about to give up !!