Solved! My acer laptop switches on, goes to desktop then after few minutes goes black as if it's frozen, only thing I can do is switch

clairefloyd69

Prominent
Nov 28, 2017
1
0
510
0
Acer laptop switches on, goes to desktop then after few minutes goes black as if it's frozen but still on, no beeps, only thing I can do is switch it off? I'm not technology savvy so am utterly clueless....I've had the screen replaced then redone bcoz of loose connection I think, any advice much appreciated, thanx x
 
Well it could be the display again (or a defective display or cable that connects it). Try this...

1. Turn the laptop off (not sleep or hibernate but off).
2. Connect an external monitor to the laptop.
3. Turn on the external monitor.
4. Turn on the laptop.

NOTE: You may have to press an "external monitor" button. Could be the f4 button or a button with two monitors on it, for the external monitor to work.

If you can see fine on the external monitor, then your attached display, or the ribbon cable that connects it, are your problem.

If you can't see on the external monitor at all, or the problem occurs on the external monitor as well, then it is probably the graphics card/GPU that is the problem, which may require the motherboard be replaced.


If when it goes black and there is a cursor still on the screen (or a white line), then try these...


Option 1 ...

1. First, while the computer is off, connect an external monitor.
2. Next turn on the computer and allow it to fully load.
3. Once loaded, press the "Windows Key" + "P" to open the "Easy Display Switcher".
4. In here select "Computer only".
5. Now shut down the computer and disconnect the external monitor.
5. Disconnect the external monitor
6. And finally restart the computer.


Option 2 ...

Make sure you wait until the computer would be fully loaded before trying this, and not try it right away like you would to say get into BIOS. This needs you to actually be where you would be when Windows Explorer loads.

1. Press "Shift" repeatedly until the "sticky keys" window shows up.

2. Now click the the link there that will lead to the "Ease of Access Center".

3. Next click "Cancel" on the the bottom right corner of the "Set Up Sticky Keys" window.

4. From here you want to click "Control Panel" on the upper left corner (it should be right beside the "Make Your Computer Easier to Use" title.

5. Locate the "Computer Settings" menu and then choose the "Recovery" icon (make sure that your view of this is by either large or small icons for easier access).

6. Now click and open "System Restore".

7. Here you want to click next on the bottom right corner (a few times) until the button "Finish" shows up and then click it. (Just follow everything prompt that the window says which will lead you to recovering your previous system, in a certain time.

8. The computer will now do the work it needs to and then reboot.


If that doesn't work, you can try the following...

You can also try doing the Ctrl+Alt+Delete and see if you can get "Task Manager" to show.


If the "Task Manager" windows shows, then choose "New Task" and then type in EXPLORER. If the desktop shows up then you need to go into "Start", "Programs", then "Accessories" and finally "Command Prompt". (Or you can do a search for CMD.)

Make sure you load the "Command Prompt" with Administrator access. Then when it loads type in....

SFC /SCANNOW

It will do a file check.

To learn more about "SFC" visit this link at Microsoft... https://support.microsoft.com/en-us/kb/929833
 
Well it could be the display again (or a defective display or cable that connects it). Try this...

1. Turn the laptop off (not sleep or hibernate but off).
2. Connect an external monitor to the laptop.
3. Turn on the external monitor.
4. Turn on the laptop.

NOTE: You may have to press an "external monitor" button. Could be the f4 button or a button with two monitors on it, for the external monitor to work.

If you can see fine on the external monitor, then your attached display, or the ribbon cable that connects it, are your problem.

If you can't see on the external monitor at all, or the problem occurs on the external monitor as well, then it is probably the graphics card/GPU that is the problem, which may require the motherboard be replaced.


If when it goes black and there is a cursor still on the screen (or a white line), then try these...


Option 1 ...

1. First, while the computer is off, connect an external monitor.
2. Next turn on the computer and allow it to fully load.
3. Once loaded, press the "Windows Key" + "P" to open the "Easy Display Switcher".
4. In here select "Computer only".
5. Now shut down the computer and disconnect the external monitor.
5. Disconnect the external monitor
6. And finally restart the computer.


Option 2 ...

Make sure you wait until the computer would be fully loaded before trying this, and not try it right away like you would to say get into BIOS. This needs you to actually be where you would be when Windows Explorer loads.

1. Press "Shift" repeatedly until the "sticky keys" window shows up.

2. Now click the the link there that will lead to the "Ease of Access Center".

3. Next click "Cancel" on the the bottom right corner of the "Set Up Sticky Keys" window.

4. From here you want to click "Control Panel" on the upper left corner (it should be right beside the "Make Your Computer Easier to Use" title.

5. Locate the "Computer Settings" menu and then choose the "Recovery" icon (make sure that your view of this is by either large or small icons for easier access).

6. Now click and open "System Restore".

7. Here you want to click next on the bottom right corner (a few times) until the button "Finish" shows up and then click it. (Just follow everything prompt that the window says which will lead you to recovering your previous system, in a certain time.

8. The computer will now do the work it needs to and then reboot.


If that doesn't work, you can try the following...

You can also try doing the Ctrl+Alt+Delete and see if you can get "Task Manager" to show.


If the "Task Manager" windows shows, then choose "New Task" and then type in EXPLORER. If the desktop shows up then you need to go into "Start", "Programs", then "Accessories" and finally "Command Prompt". (Or you can do a search for CMD.)

Make sure you load the "Command Prompt" with Administrator access. Then when it loads type in....

SFC /SCANNOW

It will do a file check.

To learn more about "SFC" visit this link at Microsoft... https://support.microsoft.com/en-us/kb/929833
 
Thread starter Similar threads Forum Replies Date
Jinx forth foeva Laptop Tech Support 1
J Laptop Tech Support 2
M Laptop Tech Support 2
C Laptop Tech Support 0
Pharoah742000 Laptop Tech Support 0
Trickerz Laptop Tech Support 0
4 Laptop Tech Support 0
D Laptop Tech Support 0
R Laptop Tech Support 2
U Laptop Tech Support 1
Rogers2019 Laptop Tech Support 1
maybeits_jack Laptop Tech Support 2
iAdarsh Laptop Tech Support 13
B Laptop Tech Support 1
A Laptop Tech Support 2
R Laptop Tech Support 1
A Laptop Tech Support 1
M Laptop Tech Support 1
G Laptop Tech Support 5
Jamile Laptop Tech Support 5
Similar threads
Question Laptop won't switch on Lenovo g400
Question ASUS Laptop UX430u freezes in sleep, or hibernation, or even when monitor switches off. I have tried everything, even running from bootable disk.
Question Sony VAIO Laptop SVF15218SNW boots for few seconds, but then immediately switches off
Question Laptop not switching on following SSD change/power cable disconnection.
Question HP laptop replaced power switch after breaking it during new hdd install now doesn't turn on
Question My laptop randomly switches on and off
Question Laptop won't switch to battery power
Question My laptop is charging but not turning on (fans not turning)
Solved! Laptop switches itself off after I turn it on, screen dead
Solved! Laptop Asus UX305F cannot turn on for a while after switched off, sleep or hibernate.
Question Laptop switches on itself, but with a black screen, please help
Question Huawei Matebook 13 Only Switching on when Charging
Question Laptop lights blink... but laptop not switching on
Question My Dell Laptop is not switching on .Keyboard lights are on but the screen is not showing .
Question Laptop turn off automatically when move
Is there a magnetic switch in laptops that cause no screen?
My Acer laptop is giving some noise while I am switching on after charing,can you tell me the reason behind?....
Solved! Acer laptop not switching ON; even No charging light
closing the laptop lid leads to switching my secondary monitor to primary
Laptop - Blank screen once desktop loaded

ASK THE COMMUNITY