PDF printed as a blank page

prootsy65

Estimable
Apr 13, 2015
2
0
4,510
0
Hi All.
I have found a solution to this see below.


Within AutoCad, go to "Options". Look in the "System" tab (should be the fifth one tab). The second group down on the left side is the "Current Pointing Device" box. It's probably set to "Wintab Compatible Digitizer ADI 4.2 - by Autodesk". Change that to "Current System Pointing Device". Then hit "OK" at the bottom
 
Thread starter Similar threads Forum Replies Date
S Laptop Tech Support 14
F Laptop Tech Support 2
J Laptop Tech Support 1
B Laptop Tech Support 7
A Laptop Tech Support 1
S Laptop Tech Support 1
T Laptop Tech Support 2
B Laptop Tech Support 1
L Laptop Tech Support 3
J Laptop Tech Support 1
P Laptop Tech Support 1
D Laptop Tech Support 1
L Laptop Tech Support 1
Doc H Laptop Tech Support 2
K Laptop Tech Support 1
J Laptop Tech Support 1
P Laptop Tech Support 5
B Laptop Tech Support 2
K Laptop Tech Support 3
O Laptop Tech Support 1

ASK THE COMMUNITY

TRENDING THREADS