Archived from groups: rec.audio.pro (More info?)
Hi,
Im new to this so help is welcome. Were shooting a dance festival
taking place in the city. Taking a mix out from the FOH (XLR +4) into
a Behringer Eurorack 1204 mixers mic in 1 and 2. The trim pots on the
mixer are minumum.
the Balanced outputs from the 1204 (XLR) are going to the XLR audio
inputs of the Beta recorder. (PVW2800)
Now there is a switch at both the inputs of the BETA recorder. options
are : Low and Hgh. High has two suboptions. +4dBu 600ohms/10k ohms
selectable.
(we have it set to the center position (600ohms i think)
I am unable to locate the manual for the recorder. Could some tell me
what purpose does the 600ohm and 10k ohm load serve ?
I am also unsure of whether its ok to run a line level signal into the
mic input of a mixer. should i instead be using XLR to TRS cables?
Though everything seems to working allright.
Thanks a ton.
Sidhu
Hi,
Im new to this so help is welcome. Were shooting a dance festival
taking place in the city. Taking a mix out from the FOH (XLR +4) into
a Behringer Eurorack 1204 mixers mic in 1 and 2. The trim pots on the
mixer are minumum.
the Balanced outputs from the 1204 (XLR) are going to the XLR audio
inputs of the Beta recorder. (PVW2800)
Now there is a switch at both the inputs of the BETA recorder. options
are : Low and Hgh. High has two suboptions. +4dBu 600ohms/10k ohms
selectable.
(we have it set to the center position (600ohms i think)
I am unable to locate the manual for the recorder. Could some tell me
what purpose does the 600ohm and 10k ohm load serve ?
I am also unsure of whether its ok to run a line level signal into the
mic input of a mixer. should i instead be using XLR to TRS cables?
Though everything seems to working allright.
Thanks a ton.
Sidhu