Hello, I would like to restore a backup I made using driveimage xml. I am fine with the normal way of doing the process, but I lost the xml file. Is there a way I can restore a drive image (.dat file) using terminal?
If not I created a different backup that I can share the data on it and maybe...
I thought speakers consisted of a basic positive and negative terminal for speaker wires. However, when i opened up my in ceiling speaker, this is the result.
There is a black and red terminals, but it leads to this box that spits out extra orange+white, and blue+white cables.
The two...
Can someone please tell me a way to fix this?
The white connector on the speaker amp is missing, so the RCA connector just plugs into a plastic hole and the ground does not connect, and music does not carry over to the speakers.
I dont think there is any room to get wire to connect the ground...
i have a Pioneer Sc1224 rated for 4-16 ohms, pair of 6 ohm Jenson X7s and a 4ohm 320W Panasonic SB-W940 subwoofer. The Sub only has bare speaker wires and the pioneer has preamp coaxial outs. I'm wondering if i could connect my sub to one of the front terminals along with my Jensons ?
Can someone please tell me a way to fix this?
the white cap on the speaker is missing, so the RCA connector just plugs into a plastic hole and the music does not carry over to the speakers. Is there a ghetto fix?
https://www.dropbox.com/s/9082x36tu5f0hyz/2014-12-18%2014.29.33.jpg?dl=0
I have an old TEAC AG-780 running all my home speakers and working fine all on from A speaker terminals. I am getting a pool and putting in a Aquasonic MONO speaker. Is there a way to hook this MONO speaker to back B terminal in Mono mode by wiring it correctly.
Here's my setup. I have a 12v battery. The positive terminal is hooked up to a 25A fuse on 10 gauge wire. The fuse leads to a 25A switch. The switch goes to my amp power. The amp is grounded to the negative terminal on the battery. The amp has power. I have 2 16 gauge wires running to the...
Picked up an extremely cheap speakerless Samsung 5.1 DVD/receiver as I already have 5.1 speakers. I found out it uses samsung proprietary speaker connector Would it hurt to use simple insulated female terminal connectors. I don't feel like spending a lot of money for Samsung connectors...
I have a new pioneer receiver which has 4 terminals for the main speakers ( 2 red + for left and right and 2 black - for left and right) . My Technics speakers have for terminals each ( black and red for low level base and grey and Blue for mid and high level). How do I connect them to the receiver?
Hello,
I have 5:1 surround speakers and only one terminal for a Surround Back speaker, not two for left and right. Surround left and right are able to mix with the SB speaker. Is this correct? Is there a way to set up left and right Back speakers? Can I (should I)connect 2 speakers to one terminal?
Hello...
My January 2010-bought LG DVD/VHS Combi Unit wikll not read ANY DVD, whether recorded by me on the machine or bought pre-recorded. When I put the DVD into the tray and close the drawer it remains on 'READ" and stays there for a few minutes and then rejects the DVD without proceeding...