4 ohms and 8 ohms speaker connected to Marantz SR6009 rated 4-16 ohms.

Oct 18, 2018
3
0
10
I have a Marantz SR6009 rated 4-16 Ohms connected to def Tech speaker system procinema 800 rated 8 ohms as 5.1 surround sound in my living room. I wanna add in the zone2 of my receiver, two OE8 speakers rated 4 ohms. I will never listen music at high volume, but:

Can I do this connection w/o harm my Marantz SR6009 or speakrs?
 
Solution
If the receiver plainly say you should change it if ANY of the speakers are 4 ohm then do that. You aren't changing the ohms of the speakers just how the receiver will react to the load. The 5.1 speakers will work fine.
Yes, but the owner manual said that if i use a 4 ohms speakers I have to decrease Ohms manually in my marantz.

Carry out the following settings when using a speaker with an impedance of 4 – 6
Ω/ohms.
1. Press and hold the main unit’s ZONE2 SOURCE and STATUS for at least 3
seconds.
“Video Format < PAL>” appears on the display.
2. Press DIMMER on the main unit twice.
“Sp.Imp. <8ohms>” appears on the display.
3. Press TUNER PRESET CH + or TUNER PRESET CH - on the main unit to
select the impedance.
6ohms: Select when the impedance for any of the connected speakers is
6 Ω/ohms.
4ohms: Select when the impedance for any of the connected speakers is
4 Ω/ohms.
4. Press the main unit’s STATUS to complete the setting.

So, If I do this, all my channels will be decreased to 4 Ohms? Even my 5.1 Speakers chanel will be decreased to 4 Ohms?

Appreciate your answer.
 


Yes, but the owner manual said that if i use a 4 ohms speakers I have to decrease Ohms manually in my marantz.

Carry out the following settings when using a speaker with an impedance of 4 – 6
Ω/ohms.
1. Press and hold the main unit’s ZONE2 SOURCE and STATUS for at least 3
seconds.
“Video Format < PAL>” appears on the display.
2. Press DIMMER on the main unit twice.
“Sp.Imp. <8ohms>” appears on the display.
3. Press TUNER PRESET CH + or TUNER PRESET CH - on the main unit to
select the impedance.
6ohms: Select when the impedance for any of the connected speakers is
6 Ω/ohms.
4ohms: Select when the impedance for any of the connected speakers is
4 Ω/ohms.
4. Press the main unit’s STATUS to complete the setting.

Than; If I do this, all my channels will be decreased to Ohms? Even my 5.1 Speakers chanel will be decreased to 4 Ohms?

Appreciate your answer.

Sorry, but I am new in forum's, :??: