Bush ac80cpl firmware

Unless the tablet has been rooted, you should be able to just do a "Hard Reset" to get it back to its original state.

NOTE: Doing this will clear 'all' the data on your tablet, so it is suggested you not choose this option unless you have to, or aren't worried about losing anything on the device.

Be sure you back up any data you want to keep, to a computer or cloud account, before doing the reset.


To "Hard Reset" the tablet...

1. Make sure that the tablet is actually powered off.

2. Remove your SD card, if there is one in the device.

3. Press the "Power" and the "Volume Up" buttons, together, until you see the start-up logo on the screen.

4. Once you can see the logo, release the buttons and allow the device to enter the "System Recovery Mode".

5. Next use "Volume Down" button to get to the "wipe data/factory reset" option When in recovery mode the "Volume Up" and "Volume Down" buttons are how to can navigate and highlight what option you need.

6. Once you have selected the "wipe data/factory reset", press the "Power" button to select that option.

7. On the following screen, repeatedly press the "Volume Down" button until the "Yes - delete all user data" option is what is selected.

8. Then press the "Power" button to hard reset the tablet.

9. If you took your SD card out in step 2, when the device is up and running again, reinsert the SD card.
 
Sep 4, 2018
2
0
10
Thankyou for your reply. I have tried your advice several times. Whilst I can get to the "recovery" screen and do a factory reset the tablet always goes into a boot loop which eventually stops at a blank darkened screen with a bscklight. The only solution I can think of is to reflash the ROM or one that suits the device. Perhaps there is an Archos equivalent ROM for the Bush AC80CPL.? The tablet seems to be searching for the system to set up?