Crossover frequency for HTM-200SE

MartinL89

Commendable
Dec 2, 2016
6
0
1,510
So I'm using the HTM-200SE for surrounds. Audyssey XT32 set the crossover frequency at 150 Hz. Is this a little too high?

They should be easily be crossed over at 80Hz, right?

Are there any negatives to manually raising the crossover to 80Hz?
 
Solution
Specs are down at 70htz mate so theyre not going to have an issue at 80htz bass response wise really.
Depends if you're using a sub aswell really in which case I wouldn't go below 100htz & let the sub handle anything below.
If you're not using a sub I'd take them right down to 70htz & see how they sound.
Specs are down at 70htz mate so theyre not going to have an issue at 80htz bass response wise really.
Depends if you're using a sub aswell really in which case I wouldn't go below 100htz & let the sub handle anything below.
If you're not using a sub I'd take them right down to 70htz & see how they sound.
 
Solution