Dish Network RF coax to HDMI converter?

[sumyunguyz]

I have an RV that has a Dish network receiver with HDMI and coax outputs. The RV is pre-wired with coax that sends the signal from the Dish receiver via coax to the TV's. I would like to have HD to one of the smart TV's however it would be a huge task to remove the ceiling to gain access to the wiring and run a long HD cable to the living room TV.
Is there any type of converter I can use that will convert the RF coax satellite signal coming from the satellite receiver to a HDMI signal to the back of the TV?
Thanks.

 

[Alabalcho]

Most (all?) TVs these days have antennae input, and this is where coax output from DVR is supposed to go (tune TV to channel 3 or 4). I doubt that this output will carry HD, though.

As for converter - I think most "Digital converters" sold couple of years ago (when TV went digital) will work, but again - I don't think you'll get HD.

 

[kango69]

You would need something like this
https/www.satellitesuperstore.com/hd_modulator_HD_over_coax.htm
https/www.amazon.co.uk/Edision-HDMI-Modulator-Full-Distribution-Black/dp/B00KBXKJ2A
Or you could use a wireless video sender like this
https/www.amazon.co.uk/ProVision-Wireless-Sender-Receiver-Transmitter/dp/B00A22MG62

 

[americanaudiophile]

You can use an HDMI over coax converter like this one
https/www.amazon.com/single-75ohm-Extender-Sender-Receiver/dp/B00HWIWEMU
that connects to an HDMI input not the tuner.