Some preface - the device in question is a laptop; specifically the HP G4 250. I've owned this for about 2 months, and this has never happened before.
So, I started reading online, and I came to the conclusion I should run a CHSDK on an admin cmd.
Rebooted my laptop - the check was stuck at 11% for about an hour. I cancelled the check by rebooting and logged back into my laptop.
Here's another problem; my laptop is running slowly at launch and takes longer to boot that usual.
I have also run two tests to test my hardware through prime95 - a 'Small FFT's ' and a 'Blend' test(s). Both were run for 20-25 minutes and my laptop had no issues going through them. what should i do?
So, I started reading online, and I came to the conclusion I should run a CHSDK on an admin cmd.
Rebooted my laptop - the check was stuck at 11% for about an hour. I cancelled the check by rebooting and logged back into my laptop.
Here's another problem; my laptop is running slowly at launch and takes longer to boot that usual.
I have also run two tests to test my hardware through prime95 - a 'Small FFT's ' and a 'Blend' test(s). Both were run for 20-25 minutes and my laptop had no issues going through them. what should i do?