Onkyo 5010 amp. Blue light went out in front and sound stop coming out. I clicked the pow

mest

Commendable
Jan 5, 2017
1
0
1,510
0
Onkyo 5010 amp. Blue light went out in front and sound stop coming out. I clicked the power button and a click occurs inside the unit like its powering up but still no light or sound coming from amp.
 
Disconnect the speaker wire & input cable from the back of the amp then try turning it on.
If the amp comes on normally then turn it off and reconnect the speaker wire one channel at a time and try it. A shorted speaker wire or bad speaker will cause the amp to go into protection. Then you can try the input cable to see if that is the problem.
If the amp still goes into protection then you will need a technician to troubleshoot it. Problem is inside the amp. Good luck.
 
Disconnect the speaker wire & input cable from the back of the amp then try turning it on.
If the amp comes on normally then turn it off and reconnect the speaker wire one channel at a time and try it. A shorted speaker wire or bad speaker will cause the amp to go into protection. Then you can try the input cable to see if that is the problem.
If the amp still goes into protection then you will need a technician to troubleshoot it. Problem is inside the amp. Good luck.
 
Thread starter Similar threads Forum Replies Date
L Audio 3
R Audio 2
Conbrue Audio 1
A Audio 3
B Audio 1
R Audio 5
C Audio 1
PLBoucher Audio 7
Loudsoothesmind Audio 2
S Audio 1
T Audio 0
M Audio 0
gediman Audio 2
N Audio 1
diesel888 Audio 1
M Audio 1
P Audio 4
hostos Audio 2
V Audio 1
N Audio 2

ASK THE COMMUNITY