sony ta 1150 integrated amplifier no output fixed

Solution
Corroded and dirty switches can cause this. With the unit off operate every switch and knob 30 times. They can sometimes clean up enough to work for a while. Switches that you don't use are the most likely to corrode.
You can check to see if there are any speaker fuses that are blown. Might be on the back or inside. If you replace them with the same amp rating fuse and they blow don't try again. It can cause additional damage.
If the amp has an internal relay that can also have corroded contacts that will cut off the output.
You can get the service manual here
https://www.hifiengine.com/manual_library/sony/ta-1150.shtml
Corroded and dirty switches can cause this. With the unit off operate every switch and knob 30 times. They can sometimes clean up enough to work for a while. Switches that you don't use are the most likely to corrode.
You can check to see if there are any speaker fuses that are blown. Might be on the back or inside. If you replace them with the same amp rating fuse and they blow don't try again. It can cause additional damage.
If the amp has an internal relay that can also have corroded contacts that will cut off the output.
You can get the service manual here
https://www.hifiengine.com/manual_library/sony/ta-1150.shtml
 
Solution

So that's the power (electricity) light, it's just telling you, am getting electricity! is not a smart, diagnostic light that will turn to red when something is wrong. I wish.

If u were playing at a high volume when this happened, check the existent of fuses. If this puppy "clicks" when it turns on, a relay may needs replacing.