PC touch screen goes nuts

Aug 23, 2018
1
0
10
Every time my Dell PC is restarted, or something is put into any port, the touchscreen goes completely nuts. I then pull up device manager and uninstall the touchscreen, but it happens again if it is restarted or any port is used. It can take a long time to do this, because the cursor is jumping all over the screen. Any solutions out there?
 
Solution
Try starting the laptop up in "Safe Mode" and see if it occurs in there. If it does, then it is probably a hardware issue and I would have the laptop looked at. If, however, it doesn't happen in there, then we are talking software issue. Bad program, virus, malware, driver update needed, etc.

How to enter "Safe Mode" when booting the computer.

In Windows 8 and 10...

As your computer restarts, press F8 (possibly a few times) to enter "Safe Mode"

a. Press the "F4" key to Enable "Safe Mode".
(The computer will then start in "Safe Mode" with a minimal set of drivers and services.)

b. Press the "F5" key to Enable "Safe Mode" with Networking.
( Once "Safe Mode" with Networking starts, Windows is in Safe Mode, with additional network and...
Try starting the laptop up in "Safe Mode" and see if it occurs in there. If it does, then it is probably a hardware issue and I would have the laptop looked at. If, however, it doesn't happen in there, then we are talking software issue. Bad program, virus, malware, driver update needed, etc.

How to enter "Safe Mode" when booting the computer.

In Windows 8 and 10...

As your computer restarts, press F8 (possibly a few times) to enter "Safe Mode"

a. Press the "F4" key to Enable "Safe Mode".
(The computer will then start in "Safe Mode" with a minimal set of drivers and services.)

b. Press the "F5" key to Enable "Safe Mode" with Networking.
( Once "Safe Mode" with Networking starts, Windows is in Safe Mode, with additional network and services for accessing the Internet and other computers on your network.)

c. Press the "F6" key to Enable "Safe Mode" with Command Prompt.
(In "Safe Mode" with "Command Prompt" starts Windows in Safe Mode, with a Command Prompt window instead of the Windows interface. This option is mostly only used by IT professionals.)

Now sign in to the computer with your account name and password. (If you have one set.) When you are finished troubleshooting, you can exit "Safe Mode" restarting your computer.


In Windows 7/Vista/XP...

1. Immediately after turning on the computer, or restarting it (usually after you hear your computer beep), tap the F8 key, repeatedly, in 1 second intervals.

2. The computer will then display hardware information and run a memory test.

3. Next the "Advanced Boot Options" menu will appear.

4. In the "Advanced Boot Options" menu use the arrow keys to select "Safe Mode" or "Safe Mode with Networking" and press ENTER.
 
Solution