struck in an endless loop of reinstallation and restarting when i shut down it in middle of windows update

swaroopsonu7

Prominent
Feb 1, 2018
1
0
510
my laptop lenovo g50 ,i shut down it when it was updating windows thinking its completed..but after when i start it again it is displaying the lenovo logo and after some time it shows a message saying " windows didn't install properly" and continues to restart endlessly ...and this displaying message and restarting process doesn't stop..what should i do?
 
Solution
Try this...

1. Turn off the laptop.
2. Turn off your WiFi, or take the laptop to an area where there isn't any WiFi. (If connected via Ethernet, unplug it.)
3. Turn on the laptop.
4. Once it fully loads, then turn on your WiFi again.

It should work now. Sometimes (especially in 10) updates, including those that come after a reset, can get the computer stuck. It happens when an update fails, for whatever reason, and the device continually tries to get it to install over and over. Leaving you 'stuck'. Until you take away its ability to continue trying the update, hence the no WiFi, then it should load.
Try this...

1. Turn off the laptop.
2. Turn off your WiFi, or take the laptop to an area where there isn't any WiFi. (If connected via Ethernet, unplug it.)
3. Turn on the laptop.
4. Once it fully loads, then turn on your WiFi again.

It should work now. Sometimes (especially in 10) updates, including those that come after a reset, can get the computer stuck. It happens when an update fails, for whatever reason, and the device continually tries to get it to install over and over. Leaving you 'stuck'. Until you take away its ability to continue trying the update, hence the no WiFi, then it should load.
 
Solution