Amplifier

Looking for decent speakers ....any suggestions? I was using my AV amp for a good system but the speakers were poorly placed for the office desk area so looking to install a more suitable solution at the desktop. Really like low end detail Really need to change these Creative T10 PC speakers!!!

hello. i have question and my english is terrible... so! sorry before :D i want to make an amplifier by 4 pieces tda7294 on bridge mode which output is stereo and the power is 150w RMS on 8ohm by 18-0-18 volt 8A transformator. also want to make 2 X 3way speakers. so my problem gonna start...

Hello dear tom'sHardware users!! I am looking forward into buying a new amp. Since I am looking forward to use them with either the new Wharfedale Diamond 11.1 or the MA Bronze 2's (which should I pick) I would like the amp to provide warm sound, especially if I go with the Bronze 2's since they...

Hi all, Recently I've encountered some issues with an old (late 1980's) amplifier I decided to get going again. For example, when the unit is turned on there is quite a loud spike that is heard through the speakers when the relays click on. This is also heard when selecting another input...

Hello guys! I am planning to build a subwoofer for my room. I have PIONEER TS-W3003D4 subwoofer. SPECS: 600w nominal 2000w max 4 Ω Also i have PIONEER GM-D8601 APM. SPECS: 600w nominal 1600w max 4Ohm 24A I am looking for a PSU that can run my AMP. I am looking at CHIEFTEC ATX 2.3 A-135...

are these speakers good combination with amplifier? Ebay Technical Pro VMPR8 Passive Speaker 700 Watts 8 Ohms X2 speaker specs > Dimensions (H x W x D): 20" x 12" x 9.5" 20-700 Watts Recommended Power 50Hz - 20kHz Frequency Response 95dB Efficiency/Sensitivity 8ohm Impedance Technical Pro...

I have a soundbar that's been sitting in my basement for a while- I believe it's custom built since there are no model numbers or anything on it other than on the individual speakers themselves- and even those are very limited. It's in a very generic housing- with the fabric on the outside and...

Hello I have a slight issue with my amplifier when its connected to my motherboard. Theres a lot of interference when I move my mouse or when things happen on screen. The only way to get rid of it a little bit is to turn the volume knobs on my amp below 5 (they go from 1 to 10) Its not a...

Hi all, I don't know anything about audio amplifiers. Could you advise me a good quality audio amplifier? it should connect devices like smartphones and ipod to high impedance headphones. They can be also not portable. thank you

Hey everyone, Okay I’m having an annoying audio issue with a new amplifier that I bought as an upgrade to my old one which was an Denon PMA520AE. Okay, before I get to the issue I begin with the setup that I’m on. Desktop: ■Core I5 6600K ■ASRock H110M Combo-G S1151 mATX Intel Motherboard...

Hello I am looking to buy an amp that will power these speakers, i do want an amp which will not distort the sound and that will able to drive these speakers loud. I am looking to spend 100-150 $ (preferably euro). If possible give me a couple of different options and price points (from 100 and...

Hello, i'm planning to build my own subwoofer but I have a problem with a part of it. the subwoofer i'm planning to buy is Pyle PLPW8D 8-Inch 800 Watt. the problem is I do not know what amplifier plate does I need to buy, I have problem with the money, so I cant buy something like this...

I have a Dayton SA100 100w Amp with 2 Aura bass transducers connected in series. I connect the amp to my PC's Center Subwoofer out with a RCA to 3.5mm cable. It gets hot even when it is not turned on. The red box is where it heats up.

I am interested in getting a bass shaker. I want I don't know which to choose. My budget is no more than $65. My current Amp is the Panasonic SA-HT940. If I were to get a small bass shaker, would it be better to put it on the bottom of my seat or back. I will be using this for my racing sim.

I'm a bit worried now about the speaker and amp config I was planning to buy. I was planning on buying a pair of Klipsch R-15M speakers which are rated 85w continuous and an amp in a few weeks, but recently saw an Onkyo tx 8020 100w (50 wpc) stereo amp on sale for about $100 and dumbly bought...

I could really use some help connecting my new reference speakers to my receiver. I previous used Tannoy powered studio monitors in my Harmon Kardon 3490 connected by monoprice XLR to Male RCA cables. I plugged them into the AUDIO Pre-Out on the receiver and this worked fine. Now I'm...

We live about 40-50 miles from tv broadcast towers in Dallas, so we recently got a long range multi-directional HDTV, flat plate antenna. It comes with an in line amplifier, but still doesn't get great reception, so I bought a Channel Master Model 3043 Distribution Amplifier with Dual outputs. I...

I have Toshiba 52HL167 TV and a Yamaha R-S202 receiver, and the two are not working together. I have a digital audio converter connected to an optical wire and the converter, and RCA plugs going from the converter to the "in" RCA ports on the Toshiba. Another RCA cable connects from the "out"...

I currently have an old 5.1 Sony system in my home, the amplifier of which is likely to expire soon, but the speakers and the sub-woofer work just fine ( I tested by hooking them up to other sources). After that, I plan on upgrading. I have decided to buy a Yamaha A/V receiver, with 9.2 at the...

I want to connect some passive speakers to my PC and need a mini amp to do so. I'm not an audiophile by any means, I just want something that'll produce decent sound for gaming/general use at a low-mid volume (I'll also probably want to mount it under my desk so preferably nothing that is too...