Home Reciever plus preamp plus amp

Nov 23, 2018
3
0
10
0
Hello I have a home receiver which doesn’t seem to have Rca pre out amp connections. I have a separate pre amp and matching amp. Can this trio be Connected to deliver an increased signal to the two speakers? Thanks.
 
Not hard at all to connect the power amp to the receiver. Use a speaker to line level converter to connect the front speaker outputs of the receiver to the amp inputs. Front left and right speakers connect to the amp. Turn on the amp and redo the set up on the receiver. Done.
Not much point in using the preamp unless you have a more audiophile orientation and want to play in stereo. Then you would connect the converter to the preamp and the preamp out to the amp. Any analog sources would be connected directly to the preamp so you could turn off the receiver. Set the preamp volume to the setting you would most commonly use, select the input you connected the converter and do the receiver set up. Mark this setting somehow so you can return to it easily. If the preamp volume is not at that setting the left and right fronts will be playing quieter or louder than they should.
You use the receiver volume control for all surround sound sources and the preamp volume control for all analog stereo sources.
 
Nov 23, 2018
3
0
10
0


 
Thread starter Similar threads Forum Replies Date
picasounds Audio 5
S Audio 1
bluebadger12 Audio 1
V Audio 1
S Audio 1
X Audio 1
S Audio 1
L Audio 2
V Audio 1
J Audio 1
K Audio 4
C Audio 2
C Audio 3
S Audio 2
T Audio 1
F Audio 6
K Audio 1
K Audio 2
Q Audio 1
5 Audio 5

ASK THE COMMUNITY