i went to install windows XP on my blank laptop (2008ish Toshiba satellite) and I got this message
Welcome to setup
this portion of the setup program prepares Microsoft (R) windows (R) XP to run on your computer
1) to set up windows XP now, press ENTER
2) to repair a windows XP installation using recovery console, press R.
3) to quit setup without installing windows XP, press F3.
I pressed ENTER and got this message
Setup did not find and hard disk drives installed in your computer.
Make sure any hard disk drives are powered on and properly connected to your computer, and that any disk-related hardware configuration is correct. This may involve running a manufacture-supplied diagnostic or setup program.
Setup cannot continue. To quit Setup, press F3
What do I do?
1) 2) 3) stand for dot points and no I don't want to buy a manufacture-supplied diagnostic or setup program.
Welcome to setup
this portion of the setup program prepares Microsoft (R) windows (R) XP to run on your computer
1) to set up windows XP now, press ENTER
2) to repair a windows XP installation using recovery console, press R.
3) to quit setup without installing windows XP, press F3.
I pressed ENTER and got this message
Setup did not find and hard disk drives installed in your computer.
Make sure any hard disk drives are powered on and properly connected to your computer, and that any disk-related hardware configuration is correct. This may involve running a manufacture-supplied diagnostic or setup program.
Setup cannot continue. To quit Setup, press F3
What do I do?
1) 2) 3) stand for dot points and no I don't want to buy a manufacture-supplied diagnostic or setup program.